3.5 In. Hard-Drive Assembly; Removing The 3.5-Inch Hard-Disk Drive Assembly - Dell OptiPlex 5090 Tower Service Manual

Steps
1. Align the hard-drive assembly at an angle to the slot on the computer.
2. Press the release tabs on the hard-drive bracket and slightly align back to insert the hard-drive assembly to the slot on the
computer chassis.
3. Connect the hard-drive data and power cables to the connectors on the 2.5-inch hard-drive module.
Next steps
1. Install the side cover.
2. Follow the procedure in

3.5 in. hard-drive assembly

Removing the 3.5-inch hard-disk drive assembly

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
20 Removing and installing components
after working inside your
before working inside your
computer.
computer.