Removing The M.2 2280 Pcie Solid-State Drive - Dell OptiPlex 5090 Tower Service Manual

Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive connector.
2. Insert the solid-state drive at a 45-degree angle into the slot on the system board.
3. Replace the screw (M2x3.5) to secure the M.2 2230 solid-state drive to the system board.
Next steps
1. Install the fan duct.
2. Install the side cover.
3. Follow the procedure in

Removing the M.2 2280 PCIe solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the fan duct.
About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
24 Removing and installing components
after working inside your
before working inside your
computer.
computer.