Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive connector.
2. Insert the solid-state drive at a 45-degree angle into the slot on the system board.
3. Replace the screw (M2x3.5) to secure the M.2 2280 solid-state drive to the system board.
Next steps
1. Install the
fan
duct.
2. Install the
side
cover.
3. Follow the procedure in
Memory module
Removing the memory module
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
About this task
The following images indicate the location of the memory module and provide a visual representation of the removal procedure.
26
Removing and installing components
after working inside your
before working inside your
computer.
computer.