How To Prepare A Cappuccino; Icleaning; Coffee Cleaning; Rinsing Of Decompression Circuit - Electrolux CLASSIC 1 Service Manual

Hide thumbs Also See for CLASSIC 1:
Table of Contents

Advertisement

3
• Press the two keys
and
same time, switch the appliance back on.
3
• Press the
icon to change the selection (eg. dn or dt).
2
• Press the
icon to change the selection (eg. dn / dt dosing
of Chrono). C0/C1).
• Switch off to exit the configuration mode or wait until the
automatic exit after 10s.
H.5

How to prepare a cappuccino

• Use a high narrow container half-full of cold milk (preferably
skimmed).
I
CLEANING
I.1

Coffee cleaning

NOTE!
for the following process use a 2 cups filter-holder and the rubber plug reference DO197 inside.
I.1.1

Rinsing of decompression circuit

• Insert and tight the filter-holder in the unit.
• Press a coffee icon to put the filter-holder under pressure, and then stop the unit. Repeat this operation several times, each time
removing the water from the filter-holder.
I.1.2

Weekly cleaning with detergent pellet

Take the 2 cups filter-holder and place the rubber plug (DO197) inside the filter.
• Put a detergent pellet above the rubber plug then insert and tighten the filter-holder in the unit.
• Keep pressed the touch
(display shows nP).
NOTE!
if chrono mode activated, press twice on the touch
2
• Press again touch
to start the automatic cycle (2s On / 8s Off – x 10 sequences).
• When the display shows rP: take off the filter-holder from the unit and wait the end of the rinsing cycle (3 x 30 seconds).
• At the stop of the automatic cycle: put back the filter holder without the plug and without coffee then start a 2 large cups cycle to
rinse it.
I.2

External cleaning

Steam output tube:
After each use, clean the steam outlet with a damp cloth and release steam for a short time to eliminate the mall residue of milk
which has been able to remain in the tube. (Remove the tip of the steam pipe for easier cleaning).
Rinsing the decompression circuit:
• Engage the cup on the unit by tightening it.
• Press a coffee touch to pressurize the cup, and then stop the unit. Repeat the operation several times by emptying the water
contained in the cup each time.
Basin grille
Remove the basin grille by lifting it up from the front. Clean the basin with a sponge.
Bodywork
Use a soft cloth and alcohol for the stainless steel parts, and a nonabrasive cleaning agent for the painted parts. Simply take care
not to scratch the painted parts.
Keyboards cleaning
IMPORTANT
Never clean keyboard with liquid when the machine is in normal operation.
• Turn OFF the machine by main switch (position 0).
• Clean the keyboards and the front panel with a smooth towel and an adequate cleaning product.
• When the cleaning is done, turn ON the main switch (position 2).
18
6
at the same time, and at the
2
3
then press the touch
.
• Keep the end-piece of the steam tube at the surface to
obtain a fine foam.
• After each use, clean the steam tube with a wet rag and
press a moment on the steam tap to eliminate the small
amount of milk remaining in the tube.
NOTE!
Be careful to not boil the milk
2
3
before pressing touch
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Classic 2Classic 3

Table of Contents