Shutting Off the Edger
To shut off the trimmer, release the trigger.
Whenever you are not using the edger or are
transporting the edger to or from the work area,
remove the battery pack.
Removing the Battery Pack
from the Trimmer
Press the battery latch on the machine to release the
battery pack and slide the battery pack out of the
machine
(Figure
5).
1. Battery latch
Figure 5
Adjusting the Depth of Cut
1.
Remove the battery from the edger.
2.
Loosen the wing nut on the wheel and move it
up or down in the track to increase or decrease
the depth
g333240
3.
Adjust the depth so that the blade barely touches
the ground when the machine is held in a normal
working position.
4.
Tighten the wing nut.
5.
Standing in a normal working position, check the
depth of cut again and correct if necessary.
11
(Figure
6).
Figure 6
g333293