Setting The Heating/Blower Level; Set Heating Time - Silvercrest SSH 600 A1 Operating Instructions Manual

Setting the heating/blower level

The fan heater has two combined heating/blowing levels.
♦ With the appliance switched on, press the SET button 6 once.
(high heating/blower level) appears on the display 3.
♦ Press the
high heating/blowing level (
level ( ).

Set heating time

The appliance has a timer that you can use to set the desired heating
time between 1 to 24 hours. Once this heating period is over, the
appliance automatically switches to standby mode.
♦ With the appliance switched on, press the SET button 6 twice.
(Continuous operation) flashes on the display 3.
♦ Press the
duration in steps of 1 hour.
♦ Press the
duration in steps of 1 hour.
NOTE
► After approx. 5 seconds without a button being pressed, the set
heating duration is accepted and the timer is activated.
► When the timer is activated, the display 3 switches every few
seconds between the set temperature and the heating duration
display.
SSH 600 A1
button 4 or the
button 4 button repeatedly to increase the heating
button 5 button repeatedly to reduce the heating
button 5 to switch between the
) and the low heating/blowing
GB │ MT │
87
■