Point the Remote Control Unit toward the Plasma
Monitor (Infrared Remote Receiver) whenever
pressing the buttons. Maximum operating range for
the Remote Control Unit is about 16.4' (5m) and 60°
in front of the Plasma Monitor.
REMOTE CONTROL BATTERIES INSTALLATION
1
Remove the battery
compartment lid.
OPEN
Press the lid
downward
and slide it.
To ensure safe operation, please observe the following precautions :
● Use (2) AA, UM3 or R06 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the Remote Control Unit to moisture, or heat.
● Do not drop the Remote Control Unit.
● If batteries have leaked on the Remote Control Unit, carefully wipe the case clean and load new
batteries.
● Risk of explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
OPERATING RANGE
OK
–
+
MENU
INPUT
VOLUME
2
Slide 2 batteries into
the compartment.
Two AA size batteries
For correct polarity (+ and –), be sure
the battery terminals are in contact
with pins in the compartment.
BEFORE OPERATION
4
60°
16.4' (5 m)
3
Replace the compartment
lid.
OPEN
Slide the lid
upward.
17