Setting-Up Plasma Monitor - Sanyo PDP42H2W Owner's Manual

PREPARATION
This Plasma Monitor uses nominal input voltages of 100-
120 V AC. It is designed to work with single-phase power
systems having a grounded neutral conductor. To
reduce the risk of electrical shock, do not plug into any
other type of power system.
Consult your authorized dealer or service station if you
are not sure of the type of power supply being in use.
Connect the Plasma Monitor to the peripheral equipment
before turning on the Plasma Monitor. (Refer to P13 ~ 15
for connection.)
CAUTION
For safety, unplug the AC Power Cord when the
appliance is not used.
NOTE ON THE POWER CORD
The AC Power Cord must meet the requirement of the country where you use the Plasma Monitor.
Confirm the AC plug type with the chart below and the proper AC Power Cord must be used.
If the supplied AC Power Cord does not match the AC outlet, contact your sales dealer.
Plasma Monitor side
8

SETTING-UP PLASMA MONITOR

CONNECTING AC POWER CORD
To the POWER CORD CONNECTOR
Plasma
on Monitor
Table Top Stand
Connect the AC Power Cord
(supplied) to the Plasma Monitor.
The AC outlet must be near this
equipment and easily accessible.
AC Outlet side
Ground
To the AC Outlet.
(120 V AC)