Messages - Panasonic DMR-ES36V Operating Instructions Manual

Messages

On the unit's display
H , F
(" " stands for a number.)
SET
(" " stands for a number.)
HARD ERR
NoREAD
PLEASE WAIT
("PLEASE" and "WAIT" are
alternately displayed.)
PROG FULL
("PROG" and "FULL" are
alternately displayed.)
UNSUPPORT
("UNSUP" and "PORT" are
alternately displayed.)
UNFORMAT
("UNFOR" and "MAT" are
alternately displayed.)
U59
U61
U88
U99
On the TV
Authorization Error
This title is not authorized to
play.
Cannot finish recording
completely.
Cannot play.
Cannot record on the disc.
Unable to format.
Please check the disc.
Cannot record. Disc is full.
Cannot record. The number
of titles has exceeded the
maximum limit.
Error has occurred. Please
press ENTER.
No disc
No VHS cassette
Now recording on DVD.
To watch the VHS playback,
connect a TV to DVD/VHS
COMMON OUT terminal at the
back of the unit, and select the
appropriate input on the TV.
Please change the disc.
Please set the clock.
The VHS cassette is
protected.
This is a non-recordable disc. ≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R,
This disc is not formatted
properly.
Rental Expired
≥An error has occurred. The number following "H" or "F" depends on the status of the unit. Check the
items in the "Error messages" section and the "Troubleshooting guide". If the service number still
does not disappear after the check, follow the Reset procedure described below.
Reset procedure: ("The unit is on but cannot be operated." l 63)
≥If the service numbers fail to clear, note the service numbers and contact a qualified service person.
≥The remote control and main unit are using different codes. Change the code on the remote control.
≥If there is no change after turning the unit on and off, consult the dealer where the unit was purchased.
≥The disc is dirty or badly scratched. The unit cannot record, play, or edit.
≥You have used a lens cleaner and it has finished. Press [<, OPEN/CLOSE] to eject the disc.
≥Displayed when the unit is started. This is not a malfunction.
≥The unit is carrying out its recovery process. You cannot operate the unit while "PLEASE WAIT" is
displayed.
≥There are already 16 scheduled recording programs. Delete unnecessary scheduled recording
programs.
≥You have inserted a disc the unit cannot play or record on.
≥You have inserted a new DVD-RW/+R/+R DL/+RW or a DVD-RAM/DVD-RW (DVD-Video format)
recorded on other equipment.
≥The unit is very warm.
The unit switches to standby for safety reasons. Wait for about 30 minutes until the message
disappears.
Select a position with good ventilation when installing the unit. Do not block the cooling fan on the
rear of the unit.
≥There was a power failure or the AC plug was disconnected while the unit was on. The unit is
carrying out its recovery process. This process restores the unit to normal operation. The unit is not
broken. Wait until the message disappears.
≥There was something unusual detected with the disc while recording, playing or transferring
(copying), there was a power failure or the AC plug was disconnected while the unit was on. The unit
is carrying out its recovery process. This process restores the unit to normal operation. The unit is not
broken. Wait until the message disappears.
≥The unit fails to operate properly. Press [Í/I, POWER] on the main unit to switch the unit to standby.
Now press [Í/I, POWER] on the main unit again to turn the unit on.
≥You are trying to play a DivX VOD contents that was purchased with a different registration code.
You cannot play the contents on this unit.
≥The program was copy-protected.
≥The disc may be full.
≥There are already 99 recorded titles ([+R] [+R]DL] [+RW] 49 recorded titles).
≥You inserted an incompatible disc (Discs recorded in PAL video, etc.).
≥The disc may be dirty or scratched.
≥Create space by erasing any unwanted titles. [RAM] [-RW‹V›] [+RW]
[Even if you erase recorded content from the DVD-R or +R, there is no increase in disc space. Available
recording space on a DVD-RW (DVD-Video format) or +RW increases when the last recorded title is
deleted. (The recording space may increase slightly when other titles are deleted.)]
≥Use a new disc.
≥Press [ENTER] to start recovery process. You cannot operate the unit while it is recovering
("SELF CHECK" appears on the unit's display).
≥You haven't inserted a disc. Correctly insert a disc that the unit can play.
≥The disc is upside down. If it is a single-sided disc, insert it so the label is facing up.
≥A video cassette is not inserted when recording programs. Insert a video cassette with an accidental
erasure prevention tab.
≥The VHS plays back while recording on DVD. You can watch the VHS playback by connect to the
DVD/VHS COMMON terminals.
≥There may be a problem with the disc. Press [<, OPEN/CLOSE] on the main unit to remove it and
check it for scratches or dirt. (The unit turns off automatically after you open the tray.)
≥The clock is not set when recording programs or setting the scheduled recording. Set the clock.
≥A video cassette without the accidental erasure prevention tab is inserted when recording programs.
Use a video cassette with an accidental erasure prevention tab.
DVD-R DL, DVD-RW (DVD-Video format), +R, +R DL or +RW.
≥You inserted an unformatted DVD-RAM, DVD-RW, +R, +R DL or +RW. Format the disc with the unit.
≥The DivX VOD contents has zero remaining plays. You cannot play it. (DivX)
≥The operation is prohibited by the unit, disc or cassette.
Page
–
–
19
–
6, 9
22
–
–
29
7
56
–
–
63
–
Page
33
–
–
–
–
9
40, 54,
55
–
–
6, 9, 22
22
10, 22
14
9
17, 20
10
–
56
33
61
30
RQT8977