Using The Info. Button; Using The Freeze Function; Using The Blank Function; Using The P-Timer Button - Panasonic PT-LX22E Operating Instructions Manual

Basic operations by using the remote control
Note
The white arrows indicate that there is no correction.
z
A red arrow indicates the direction of correction.
z
An arrow disappears at the maximum correction.
z
If you press the <KEYSTONE> button on the remote
z
control once more while the keystone dialog box is being
displayed, the keystone adjustment will be canceled
( Æ page 45).
The adjustable range is limited depending on the input
z
signal.

Using the INFO. button

This function allows you to display the [information]
menu.
Button
Press <INFO.> button on the remote
control.
Note
For details, see "Input Source Information Display " in
z
"Information" under Main menu (

Using the FREEZE function

You can freeze the projected image temporarily,
regardless of the playing condition of the connected
device.
Button
Press the <FREEZE> button on the remote control to
freeze the picture on the screen. To cancel the Freeze
function, press the <FREEZE> button again or press
any other button.
Fig.1 will appear on the screen while the Freeze
function is working.
Fig.1
30
- ENGLISH
page 53).
Æ

Using the BLANK function

Button
Press the <BLANK> button on the remote control to
black out the image. To restore to normal, press the
<BLANK> button again or press any button.
When the Logo is not set,
z
press the <BLANK> button as follows.
you
projected image
black out
When
the projected Logo (the logo can be set according
z
to users' favorite) is transferred from computer to
the projector by "Logo Transfer Software" on the
supplied CD-ROM and is set as [User] in the Logo
Æ
selection( page 47), the screen changes each time
you press the < BLANK> button as follows.
Logo
black out

Using the P-TIMER button

Press the <P-TIMER> button on the remote control to
operate the [Count up/Count down] function.
Button
Press <P-TIMER> button on the remote
control.
Note
To stop the count time, press the <P-TIMER> button.
z
To cancel the [P-timer] function, press and hold the
Æ
<P-TIMER> button. ( page 48)

Using the LAMP button

This function allows you to select the lamp mode for
changing the brightness on the screen.
Button
the screen changes each time,
projected image