Table of Contents
Advertisement
TCD320FX(e).book Page 33 Tuesday, January 18, 2005 1:25 PM
If you select "No Ringing", the base unit
will not ring during night mode.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
34).
4
Select "Ringer Setup", then press
,.
5
Select "Night Mode", then press
,.
6
Select "Ring Delay", then press
,.
7
Select the desired setting, then press
,.
8
Press {ih}.
Call options
Setting dialling mode
(tone/pulse)
"Tone": Select when you have a touch tone
service.
"Pulse": Select when you have rotary or
pulse service.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
34).
4
Select "Call Options", then press
,.
5
Select "Dial Mode", then press ,.
6
Select the desired setting, then press
,.
7
Press {ih}.
Base Unit Settings
Changing the recall time
Change the recall time, if necessary,
depending on the requirements of your
service provider or PBX.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
34).
4
Select "Call Options", then press
,.
5
Select "Recall", then press ,.
6
Select the desired setting, then press
,.
7
Press {ih}.
Setting pause length
Change the pause length, if necessary,
depending on the requirements of your
service provider or PBX.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
34).
4
Select "Call Options", then press
,.
5
Select "Pause Length", then press
,.
6
Select the desired setting, then press
,.
7
Press {ih}.
Storing/changing emergency
numbers
These settings determine which phone
numbers can be dialled while the call bar
feature is on (page 28).
1
Press $ (middle soft key).
33
Advertisement
Table of Contents
