Table of Contents
Advertisement
TCD320FX(e).book Page 50 Tuesday, January 18, 2005 1:25 PM
Answering System Features
L You can hang up, or enter your remote
access code again and begin remote
operation.
Guide to answering
system settings
If the base unit is reset to its default settings
(page 35), the following answering system-
related settings will be reset.
Answering
Default
system
setting
setting
Answering
Answer On
system on/off
Remote
access code
Number of
4 Rings
rings
Caller's
3 Minutes
recording time
Call screening
On
Message alert
Off
Changing the number of rings
You can change the number of times the
phone rings before the unit answers calls.
You can select 2 to 7 rings, or "Auto".
"Auto": The unit answers after 2 rings when
new messages have been recorded, and
after 5 rings when there are no new
messages. If you call your phone from
outside to listen to new messages (page
48), you will know that there are no
messages when the phone rings for the 3rd
time. You can then hang up without being
charged for the call.
1
Press $ (middle soft key).
2
Select u, then press ,.
50
3
4
5
6
Selecting the caller's recording
time
You can change the maximum message
recording time allotted to each caller, or set
the unit to greet callers but not record
Page
messages.
1
page
2
45
3
—
page
4
48
page
5
50
page
6
50
page
Note:
50
L When the message recording time is set
page
50
Turning call screening on/off
While a caller is leaving a message, you can
screen the call through the handset speaker.
1
2
3
4
5
6
Turning message alert on/off
This feature alerts you when new messages
have been recorded. The base unit beeps
Select "Settings", then press ,.
Select "Number of Rings", then
press ,.
Select the desired setting, then press
,.
Press {ih}.
Press $ (middle soft key).
Select u, then press ,.
Select "Settings", then press ,.
Select "Recording Time", then press
,.
Select the desired setting, then press
,.
Press {ih}.
to "Greeting Only" and the answering
system is turned on, d is displayed.
Press $ (middle soft key).
Select u, then press ,.
Select "Settings", then press ,.
Select "Call Screening", then press
,.
Select "On" or "Off", then press ,.
Press {ih}.
Advertisement
Table of Contents
