Table of Contents
Advertisement
TCD320FX(e).book Page 63 Tuesday, January 18, 2005 1:25 PM
SMS (Short Message Service)
Problem
I cannot send or receive SMS
messages.
"FD" is displayed.
"FE" is displayed.
"E0" is displayed.
"Q" is not displayed after you read
a message. An error code ("FD",
"FE", or "E0") is displayed.
Answering system
Problem
The other party complains that they
cannot leave a message.
Cause & solution
L You have not subscribed to the appropriate service.
Consult your service provider.
L The SMS message centre number(s) are not stored
or are incorrect. Store the correct numbers (page
39).
L Message transmission was interrupted. Wait until
the message has been sent before using other
telephone functions.
L SMS message memory is full. Erase unnecessary
message in the receive and send lists (page 41).
L Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
L The unit could not connect to the SMS message
centre. Confirm that the correct SMS message
centre numbers are stored (page 39). Confirm that
SMS is turned on (page 39).
L An error occurred while sending the message. Try
again.
L Your phone number is permanently withheld or you
have not subscribed to the appropriate service.
Consult your service provider.
L When an error code is displayed, "Q" will not be
displayed even if you have read the message.
Cause & solution
L The recording time is set to "Greeting Only".
Select "1 Minute" or "3 Minutes" (page 50).
L Message memory is full. Erase unnecessary
messages (page 46).
Useful Information
63
Advertisement
Table of Contents
