Miter Detent - Bosch CM12SD Operating/Safety Instructions Manual

BM 1609B04985 11-14_CM12SD 11/12/14 2:52 PM Page 27
Using the Miter Detent
1. Loosen the miter lock knob about 1/2 turn (see figure
33).
2. Grip the lock knob, and then reach down with your
index finger to pull up on the miter detent lever – pull
lever until it is out from the miter detent plate.
3. While gripping the miter lock knob and miter detent
lever, rotate the saw's table. Stop table rotation at the
desired angle as indicated by the miter scale pointer.
4. Release the miter detent lever into a detent in the
miter detent plate or at an angle between detents. If
close to a miter detent, use the miter detent override
feature.
5. Tighten the miter lock knob before cutting.
NOTE: It is recommended to tighten the miter lock knob
before all cuts. It is required to tighten the knob before
cutting at any angle between detents or when the miter
detent override system is in use.
Miter Detent Override
The miter detent override feature allows the miter detent
action to be locked out, allowing for micro adjustments
at any miter angle. When the desired miter angle is too
close to a standard mitering angle that has a detent slot,
this feature prevents the wedge on the miter detent
lever from slipping into the detent slot on the miter
detent plate.
1. Lift and hold the miter detent lever.
2. Push the detent override clip forward and latch in
place over clip edge. Release miter detent lever
(figure 34).
3. Rotate table to any position on the miter scale.
4. Lock the miter lock knob to retain miter position.
Loosen miter lock knob and lift the miter detent lever to
release the detent override clip. The clip should
automatically disengage and the table should lock into
any desired miter detent.
Adjusting front stabilizing foot
The front stabilizing foot is located at the front of the
saws table near the detent override (figure 34) this foot
provides additional support and stability when making
slide cuts. To adjust the foot to the work surface follow
these steps:
1. Place the saw on the intended work surface.
2. Set desired miter angle.
3. Unscrew (turn counter clockwise) the front stabilizing
foot until it contacts the work surface.
preparing for Saw Operations

Miter Detent

To Disengage:
Detents
Detent
plate
Stabilizing
front
Stabilizing
foot
4. Screw in (turn clockwise) the front stabilizing foot if it
prevents the tool from making full contact (all four
base feet touching) with the work surface.
Note: if the saw is firmly attached to a bench using all
mounting holes the front stabilizing foot can be adjusted
clockwise into the saw and does not need to be adjusted
to the work surface (refer to Page 21, How to mount the
saw to a bench).
27.
FIG. 33
front Miter Miter
Detent lock
foot
lever Knob
Clip Edge
Detent
Override
Clip
Miter
lock
Knob
FIG. 34
Miter
Detent
lever