Binding Cables; Setting The Usb Flash Drive Cover - Sharp PN-H801 Operation Manual

The cables connected to the terminals on the rear of the monitor can be fastened with the cable clamp.
*1
Cable
Cable clamp
attachment
Cable clamp
*2
Cable clamp
(insertion type)
Cable clamp
attachment

Setting the USB flash drive cover

1. Insert the USB flash drive into the USB port.
Caution
• Do not tighten the screw excessively. Excessive tightening may damage the monitor.
TIPS
• If the USB flash drive cover will be attached, use a USB flash drive with dimensions no greater than 1-15/16 inch (50 mm) (L)
× 13/16 inch (20 mm) (W) × 1/2 inch (12 mm) (H).

Binding Cables

Cable
USB port
*3
*3
Cable clamp
(for power cord)
Cable clamp
attachment
2. Remove the screw from the monitor, attach the USB
flash drive cover, and fasten with the screw that you
removed.
*1
*1
*1
*1
*1
*1
*2
Cable
Screw
*1
*1
15
E