Table of Contents
Advertisement
nIP CONTROL SETUP
1. Set IP control setup to ENABLE.
Select IP CONTROL SETUP with
ENTER
. Select CHANGE and press
ENTER
and press
or
2. Configure advanced security settings.
Select DETAIL SETTING with
Select CHANGE with
3. Set the login information.
Enter the LOGIN ID and PASSWORD with the software
keyboard (see page 29).
4. Select NEXT and press
5. Set the control port.
Enter the CONTROL PORT with the software keyboard (see
page 29).
6. Select NEXT and press
7. Check your settings, select COMPLETE with
ENTER
and press
.
and press
or
ENTER
. Select ENABLE with
.
and press
or
ENTER
and press
.
or
ENTER
.
ENTER
.
or
Controlling the Monitor with a PC (LAN)
Command-based control
You can control the monitor using control commands
(see page 33) via terminal software and other appropriate
applications.
Read the manual for the terminal software for detailed
instructions.
ENTER
.
(1) Connect the PC to the monitor.
Use a commercially available LAN cable to connect a PC
to the monitor. (See page 36.)
(2) Send commands to control the monitor.
• The commands used are the same as those for RS-
232C. Refer to the communication procedure (see
page 31) for operation.
• Usable commands are provided in the control
command table (see page 33).
,
37
E
Advertisement
Table of Contents
