Beko WTV 7531 X0 User Manual page 5

2 Installation
Refer to the nearest Authorised Service Agent for installation of the
product. To make the product ready for use, review the information
in the user manual and make sure that the electricity, tap water
supply and water drainage systems are appropriate before calling the
Authorized Service Agent. If they are not, call a qualified technician
and plumber to have any necessary arrangements carried out.
C
NOTE :
Preparation of the location and electrical, tap water
and waste water installations at the place of installation is
under customer's responsibility.
NOTE :
Make sure that the water inlet and discharge hoses
as well as the power cable are not folded, pinched or crushed
while pushing the product into its place after installation or
cleaning procedures.
B
DANGER:
Installation and electrical connections of the
product must be carried out by the Authorized Service Agent.
Manufacturer shall not be held liable for damages that may
arise from procedures carried out by unauthorized persons.
A
CAUTION:
Prior to installation, visually check if the product
has any defects on it. If so, do not have it installed. Damaged
products cause risks for your safety.
2.1 Appropriate installation location
• Place the machine on a rigid floor. Do not place it on a long pile
rug or similar surfaces.
• Total weight of the washing machine and the dryer -with full load-
when they are placed on top of each other reaches to approx.
180 kilograms. Place the product on a solid and flat floor that has
sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where temperature may fall
below 0ºC.
• Place the product at least 1 cm away from the edges of other
furniture.
2.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging reinforcement.
Remove the packaging reinforcement by pulling the ribbon.
5 / EN
2.3 Removing the transportation locks
A
WARNING:
Do not remove the transportation locks before
taking out the packaging reinforcement.
WARNING:
Remove the transportation safety bolts before
operating the washing machine! Otherwise, the product will
be damaged.
1. Loosen all the bolts with a suitable spanner until they rotate freely
(C) .
2. Remove transportation safety bolts by turning them gently.
3. Attach the plastic covers supplied in the User Manual bag into the
holes on the rear panel. (P)
C
NOTE :
Keep the transportation safety bolts in a safe place
to reuse when the washing machine needs to be moved again
in the future.
NOTE :
Never move the product without the transportation
safety bolts properly fixed in place!
Washing Machine / User's Manual