Anti-Scalp Rollers; Caster Wheels; Cleaning - Husqvarna Z 246 Operator's Manual

MAINTENANCE
front. Adjust nuts until rear of mower deck is
positioned level to 3,175 mm higher in the
rear than the side-to-side measurement.
NOTE: For illustration, the front foot rest has been
removed. The adjustment can be made without
removal.
NOTE: This will position the mower deck in a
standard measurement position. Depending on
the type of grass being mowed or environmental
conditions, more adjustments can be required to
get the correct cut.

Anti-scalp Rollers

Anti-scalp rollers are correctly adjusted when
they are slightly off of the ground when the deck
is at the correct cutting height in the operating
position. Anti-scalp rollers keep the deck in the
correct position to prevent scalping in most terrain
conditions.
The anti-scalp rollers can be set in three
positions:
• Upper 3,81 cm to 6,35 cm grass
• Middle 6,35 cm to 10,16 cm grass
• Lower 10,16 to 15,24 cm grass.
The rollers must be approximately 6,35 mm from
the ground.
Hardware
Check daily. Do an inspection of the machine for
loose or missing hardware.

Caster Wheels

Check at 200 hour intervals. Check that wheels
turn freely. If wheels do not turn freely take the
unit to your dealer for service.
Foam filled tires or solid tires will void the
warranty.
Removal and installation
Remove the nut and caster bolt. Pull the wheel
out of the yoke and take care of the spacers.
Install in reverse order. Tighten caster bolt.

Cleaning

Regular cleaning, especially under the mower
deck, will increase the machine's life-span. Clean
the machine directly after use (after it is cool,
before the debris sticks. Do not rinse hot surfaces
with cold water.
Do not spray water on the top of the mower deck.
Use compressed air to clean the top side of the
mower deck. Do not use a high pressure washer
or steam cleaner. Avoid spraying engine and
electrical components with water.
Clean the underside of the deck with normal
water pressure. Attach the quick connect (from
the accessory packet) to a garden hose. After
mowing, snap the hose to the cleanout port and
turn on water supply.
Restart the mower and engage the blades to use
the spinning action to wash away debris. Make
sure the hose is away from the mower blades.
CAUTION! Use protective glasses
when cleaning and washing.
25