Engine Oil; Wheel And Deck Zerks; Transmission - Husqvarna Z 246 Operator's Manual

LUBRICATION

Engine Oil

NOTE: Change the engine oil when the engine
is warm. Refer to the engine owner's manual
for the correct replacement oil and filter change
recommendations.
WARNING! The engine drain plug is
located near to the muffler. To prevent burns,
the engine should be shut off and allowed to
cool slightly so the engine is still warm but the
surrounding surfaces and oil are not.
1. Park on a level surface. Engage park brake.
2. Clean the dirt and debris from the area around
the oil fill cap.
3. Remove the cap/dipstick.
4. Find the drain hose at the right rear of the
engine near the bypass linkage. Put an
adequately sized container under the end of
the drain hose and remove the oil drain plug.
5. Let the used oil fully drain from the engine.
6. Replace the drain hose plug and tighten
securely.
7. Fill the engine with new oil to the bottom of
the fill tube threads. Check the level with the
dipstick.
8. Replace the oil fill cap securely when the oil
level is FULL.
9. To discard the used oil, refer to local disposal
regulations.
10. Refer to the Service Journal for oil checking
and changing intervals and change
recommendations

Wheel and Deck Zerks

Use only good quality bearing grease. Grease
from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Front Wheel Mount
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Front Wheel Bearings
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Deck Spindles
Lower the cutting deck fully. Lubricate with a
grease gun, 2-3 strokes per spindle through the
openings in the belt shields.

Transmission

The transmission is maintenance free. It is not
necessary to do level checks or oil changes. If
a leak occurs, replace the unit or contact your
Husqvarna dealer.
27