Lubrication - Husqvarna Z 246 Operator's Manual

LUBRICATION

12/12 Each year
1/52 Each Week
1/365 Each day
General
Remove the ignition key to prevent accidental
movements during lubrication.
When lubricating with an oil can, it must be filled
with engine oil.
When lubricating with grease, unless otherwise
stated, use a high grade molybdenum disulphide
grease.
For daily use, the machine must be lubricated
twice weekly.
Clean away unwanted grease after lubrication.
It is important to avoid getting lubricant on the
belts or the drive surfaces of the belt pulleys.
If this occurs, try to clean them with spirits. If
the belt continues to slip after cleaning, the belt
must be replaced. Gasoline or other petroleum
products must not be used to clean belts.
26
Lubricate with grease gun
Filter change
Oil change
Level check
WARNING! Escaping hydraulic oil under
pressure can have sufficient force to penetrate
the skin, causing dangerous injury. If injured
by escaping fluid, see a doctor immediately. If
correct medical treatment is not administered it
can cause a dangerous infection or reaction.
IMPORTANT INFORMATION Use minimal
lubrication and remove unwanted lubricant so
it does not come into contact with belts or belt
pulley drive surfaces.