D-Link DVC-1100 Manual page 11

Using the Setup Wizard (continued)
Wireless Site Survey Screen
To use your DVC-1100 wirelessly, it is necessary to find an available wireless
network. The Wireless Site Survey screen makes this simple. Upon starting,
the DVC-1100 performed a "site survey" looking for wireless network devices
the DVC-1100 can connect to. These discovered wireless devices are displayed
by their SSID name on the Wireless Site Survey screen. On a home network,
you may have just one entry. In a business, there may be numerous wireless
devices listed.
The Enable Wireless checkbox is checked by default. This allows the
DVC-1100 to be used wirelessly. If an Ethernet network cable is used instead,
uncheck this checkbox and press Next to continue setup for a wired network as
described on page 15.
To setup for wireless operation,
use the remote
up/down arrow button to select
the SSID of the device you will
connect the DVC-1100 to. Typi-
cally, this will be a wireless router
or access point.
Press ENTER on the remote to select this SSID and the Wireless Settings
screen will appear (described on the following page).
Note: The number to the left of the SSID indicates the signal strength of
the available access point on the wireless network.
If necessary, you can press the Scan button to perform an updated wireless site
survey scan. The DVC-1100 will update the SSID list.
To access the Wireless Settings screen without selecting a SSID, press the
Settings button.
Press the Next button to proceed to the Wireless Settings screen (if you are
using the DVC-1100 wirelessly) or the Network Address screen (if you are
using an Ethernet cable.)
47 i2eye AP
control
42 Router
36 Default
36 Daisy95
33 Study001
18 Sam's AP
11