D-Link DVC-1100 Manual page 20

Using the DVC-1100 (continued)
If a Status Icon is displayed, this indicates the operation the icon represents is
not complete. The i2eye Update status icon
icon appears, the DVC-1100 is quickly determining if auto-update is enabled. If it
is enabled, the DVC-1100 will determine if an update exists. When this is complete,
the icon disappears.
If the DVC-1100 cannot connect to the update server, the operation was
unsuccessful and the icon will show as:
is not connected to the Internet.
The Public IP Status Icon,
to connect to the Internet and determine the Public IP address of your Internet
connection. If this operation is unsuccessful and the icon shows as:
DVC-1100 cannot be used over the Internet. It may still be used on an internal
network as an internal videoconferencing system.
The Directory Service Status Icon
DVC-1100 is registering with the i2eye Directory Service to allow phone number
dialing. If the Directory Service cannot be reached, the
means you cannot use telephone numbers call other VideoPhones, but you can
still make VideoPhone calls by inputting the IP address of the phone that you are
calling. (See Entering IP Addresses on page 27.)
The Wireless Status Icon
connect to the selected wireless network. If the DVC-1100 cannot connect to
the selected wireless network, the
configuration problem exists.
For help, see the Troubleshooting section starting on page 55 if any of the
Status Icons show an unsuccessful operation has occurred.
Typically, this means the DVC-1100
appears at startup when the DVC-1100 attempts
is displayed at startup, showing the
appears at startup while the i2eye attempts to
icon appears, indicating a wireless
appears at startup. While the
icon appears. This
the
20