D-Link DVC-1100 Manual page 42

Using the Configuration Menu (continued)
Main Screen > Settings > Network > Wireless Site Survey
Upon startup, the DVC-1100 performs a "site survey" looking for available wire-
less networks. Any discovered wireless devices are displayed by their SSID
name. On a home network, you may have just one entry. In a business, there
may be numerous wireless devices listed. The number to the left of a SSID
indicates the signal strength of the available access point on the wireless
network.
The DVC-1100 also displays the result of the SSID that is currently selected.
Connection OK
connection fails the message Connection Failed appears. See the
Troubleshooting section starting on page 55 for help.
Enable Wireless
Scan
Settings
Close
Use the remote control up/down arrow buttons to select the SSID of the device
you will connect the DVC-1100 to. Press ENTER on the remote to select this
SSID and the Wireless Settings screen will appear (see next page.)
47 i2eye AP
42 Router
36 Default
36 Daisy95
33 Study001
18 Sam's AP
message appears if the connection is successful. If the
The checkbox is checked by default, allowing the
DVC-1100 to be used wirelessly. If an Ethernet
network cable is used to connect to a network
instead, uncheck this checkbox and press Close to
return to the Network Settings screen.
Press to update the SSID list of wireless devices.
Press the Settings button to access the Wireless
Settings screen to edit the SSID name and to set
wireless encryption settings.
Press to return to the Network Settings screen.
A
42