Table of Contents
Advertisement
Each data port is configured as shown below, as data route-through ports for all
data pins (pins 1, 2, 3 and 6). Be certain to use Category 5 or higher cabling to
ensure proper operation. This PoE Midspan is not compatible with Gigabit
Ethernet, any Gigabit Ethernet Capable device will only link at 100Mbps Full
Duplex when connected to the DWL-P1012. IEEE 802.3af compliant Power
Source Equipment will not energize the unused pairs unless an 802.3af
compliant Powered Device signals the Power Source Equipment that it is ready
to receive power.
Power on
The DWL-P1012 must be used with AC power sources 100 - 240 VAC, 50 - 60
Hz. The DWL-P1012's power supply will adjust to the local power source
automatically.
Plug one end of the PC power cord into the AC power connector of the DWL-
P1012 and the other end into the local AC power outlet.
7
Advertisement
Table of Contents
