Hitachi PSC-A32MN Operation Manual page 25

NOTES:
• By tapping "<" or ">" at the detailed setting screen, the remote control switch Permitted/ Prohibited will be
switched to another group in the same block.
• Control Prohibited (Run/Stop Only) : In case of "Enable", each Setting Change is for all Groups or Blocks.
Setting Change is not possible for each Group.
• Even if remote control switch is set as "Prohibit.", it is possible to stop operation with the remote control
switch while running. It is also possible to restart operation using the remote control switch. However, the
Stop operation will be only used in the case of an emergency. Do not use it in normal operation.
• If "Power Supply ON/OFF" (d1, d3) is set, do not set the remote control switch as "Prohibit.". If the remote
control switch is restricted when using "Power Supply ON/OFF", the function "Control lock" for the remote
control switch shall be used.
• If a communication error occurs, the remote control switch "STOP" (by item) may be cancelled. In this
case, do the setting again.
• Do not set the prohibiting operation if multiple centralized controllers are used in the same H-LINK.
Additionally, do not set this by other centralized controller or it may cause malfunction.
P5415644
19