Cleaning The Water Tank, Water Tray And Nanocloud Rotary Humidification Wick; Cleaning The Pre-Filter - Philips AC2729 User Manual

Cleaning the water
tank, water tray and
NanoCloud rotary
humidification wick
Note
•
Cleaning the water tank, water
tray and NanoCloud rotary
humidification wick every week to
keep them hygienic.
1
Pull out the water tank (fig. j).
2
Lift the water tray upwards and pull
it out horizontally (fig. k).
3
Take the wick wheel off the wick
support (fig. †).
4
Rinse the water tank, water tray and
NanoCloud rotary humidification
wick under a running tap.
Note
•
Do not take the NanoCloud rotary
humidification wick off the wheel
during cleaning.
•
Do not scrub the NanoCloud rotary
humidification wick or place it under
direct sunlight.
•
If necessary, use a mild detergent to
clean the water tank and water tray.
In this case, rinse the water tank and
water tray thoroughly.
5
Wipe the outside of the water tank
and water tray dry.
6
Place the wick wheel on the wick
support (fig. m).
EN
14
Note
•
When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
7
Place the water tray back into the
appliance (fig. n).
8
Place the water tank back into the
appliance (fig. r).

Cleaning the pre-filter

Note
•
If the pre-filter is damaged, worn or
broken, do not use. Visit
www.philips.com/support or
contact the Consumer Care Center
in your country.
Filter alert light
status
F0 displays on the
screen and wick&
pre-filter cleaning
alert goes on
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig. c).
2
To remove the pre-filter, press the
clip down and pull the filter towards
you (fig. d).
3
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig. ‡).
4
Air dry the pre-filter.
Follow this
Clean the pre-
filter