Replacing the
NanoCloud rotary
humidification wick
Filter alert light status Follow this
F1 is displayed and
the filter replacement
light
flashes on the
screen (fig. ).
1
Take the wick wheel off the wick
support (fig. †).
2
Grip the shaft screw on the
other side of the wheel, rotate it
anticlockwise to release the wick
from the wheel (fig. ).
3
Unfasten the locks on the edge
of the wheel successively to
disassemble the wick wheel (fig. ).
4
Take the used NanoCloud rotary
humidification wick out (fig. ).
5
Remove all packaging material
of the new NanoCloud rotary
humidification wick (fig. l).
6
Place the new NanoCloud rotary
humidification wick in the wick
wheel, and then fasten the locks on
the wick wheel (fig. ').
7
Place the wick wheel on the wick
support (fig. m).
Note
•
When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
8
9
Replace the
NanoCloud
rotary
humidification
wick
Place the water tray and water tank
back into the appliance (fig. n).
Touch and hold
for 3 seconds
to reset the NanoCloud rotary
humidification wick lifetime counter.
EN
17