Programmable Controller Setting; Parameter Settings Of The Cpu Module - Mitsubishi Electric MELSEC iQ-R Series Introduction Manual

4.2

Programmable Controller Setting

Parameter settings of the CPU module

Start GX Works3, set the IP address and subnet mask of the CPU module, and configure the event history, external device
configuration, and clock settings.
Own node settings
Operating procedure
1.
Display the own node setting window.
[Navigation] window  [Parameter]  Module to be used  [Module Parameter]  [Basic Settings]  [Own Node
Settings]
2.
Set the IP address and subnet mask of the module to be used.
• If the IP address is blank, it is automatically set to 192.168.3.39.
• Set the IP address of the CPU in the same segment as the IP address of the network camera set in the
following.
Page 25 Network Camera Setting
4 CAMERA RECORDING FUNCTION
4.2 Programmable Controller Setting
4
38