LG WM4500H A Series Owner's Manual page 24

24 OPERATION
Time and Status Display
Cycle Status Indicators
a
• These LEDs will blink when a cycle is selected to indicate which stages will run.
• When a cycle is running, the LED for the active stage will blink, and the LEDs for the remaining stages
will remain steady. Once a stage is complete, the LED will turn off. If a cycle is paused, the active stage
LED will stop blinking.
Estimated Time Remaining
b
• When a cycle is selected, the default time for that cycle is displayed. This time will change as modifiers
or options are selected.
• If the display shows
size.
• The time shown is only an estimate. This time is based on normal operating conditions. Several
external factors (load size, room temperature, incoming water temperature, etc.) can affect the actual
time.
NOTE
• Once the Start/Pause button is pressed, the washer will measure the size of the load. The estimated
time may change once the load size has been measured.
• If the Delay Wash function is set, the remaining delay time counts down until the cycle begins.
AI DD Indicator
c
• AI DD provides the appropriate drum rotation actions after load sensing is completed.
• This indicator lights up when:
- the Normal cycle is selected and operated, except for when the Heavy soil level is selected.
- the Bright Whites
Door Lock Indicator
d
• This indicator lights up when the cycle starts and the door is locked.
• The indicator light stays on until the cycle is paused, stopped or has finished.
Wi-Fi Indicator
e
• This indicator is lit when the product is connected to a home Wi-Fi network.
Remote Start Indicator
f
• This indicator lights up when the Remote Start feature is activated.
, then the time will be displayed after the load sensing has detected the load
---
TM
and Rinse+Spin cycles are selected and operated with any cycle options.