LG WM4500H A Series Owner's Manual page 45

Problem
Oversudsing of detergent
svd
• Do not add more than the manufacturer's recommended amount of detergent.
OVERSUDSING
DETECTION
• To remove suds, turn the washer off then back on, then run the Rinse+Spin cycle.
• If too many suds are detected during spinning, the washer stops to help prevent leaking.
Water level is too low or high compared to the load.
PF
• Unplug the washer and wait for 60 minutes. Reconnect power and try again.
WATER LEVEL
SENSOR ERROR
• If the error code is still displayed, call for service.
Inlet hose, drain hose or drain pump is frozen.
FF
• See Care in Cold Climates.
FROZEN ERROR
The Control Lock function is on to prevent anyone from changing cycles or operating
CL
the washer.
CONTROL LOCK
• Turn off the Control Lock function in the control panel. See Control Lock under Options
FUNCTION
It is time to run the Tub Clean cycle.
tcL
• This is not an error code. It indicates that the Tub Clean cycle is running or needs to be run
TUB CLEAN ALARM
Vibration sensor malfunctions.
vs
• Call for service.
VIBRATION SENSOR
ERROR
ezDispense Error Messages
Problem
The amount of liquid detergent in the detergent reservoir did not decrease.
E d1
After putting the detergent into the detergent reservoir, it was left for a long time and
ezDispense ERROR 1
the detergent hardened.
• Clean the detergent reservoir thoroughly, fill it with liquid detergent, install it in the
The amount of liquid detergent in the detergent reservoir did not decrease.
E dz
• Call for service.
ezDispense ERROR 2
The amount of fabric softener in the softener reservoir did not decrease.
E d3
After putting the fabric softener into the softener reservoir, it was left for a long time
ezDispense ERROR 3
and the fabric softener hardened.
• Clean the softener reservoir thoroughly, fill it with liquid fabric softener, install it in the
The amount of liquid fabric softener in the softener reservoir did not decrease.
E d4
• Call for service.
ezDispense ERROR 4
The amount of liquid detergent/ fabric softener in the detergent/ softener reservoir did
E ds
not decrease.
ezDispense ERROR 5
• Call for service.
The washer was operated without completely closing the drawer.
O PN
The drawer was opened during the washer operation.
ezDispense OPEN
ERROR
• Push the drawer completely closed. If
and Extra Functions.
to clean the washer drum.
drawer, and run a wash cycle. If
drawer, and run a wash cycle. If
Possible Cause & Solution
Possible Cause & Solution
is displayed continuously, call for service.
E d1
is displayed continuously, call for service.
E d3
is displayed continuously, call for service.
O PN
TROUBLESHOOTING 45