Hitachi EP-A9000 Instruction Manual page 15

4
Install the filter assembly to the unit
CAUTION
Do not put excessive force and deform
the filter assembly.
If the filter assembly is deformed, it will
not be detected by the unit.
" " will be displayed on the
temperature / humidity monitor, and the
unit will not be able to operate.
5
Install the pre-filter to the unit
Securely plug the tabs of the pre-filter to the matching holes in the unit.
Slide the switch downwards (2 locations) to lock.
Gently pull the pre-filter to make sure it is not out of place.
1
Plug the tabs of the pre-filter
6
Attach the panels to the unit
Plug the tabs (2 locations) of the
upper part of the rear panel to
the matching holes in the unit.
Gently push the bottom sides of
the panel one after another, and
close it securely until it clicks.
7
Check that the water tray set with
humidifying filter is installed in
the unit.
If the humidifying filter is not installed, "
appear in the temperature / humidity monitor
and the unit will not operate.
CAUTION
Securely insert the humidifying filter, making
sure that it is pressed until it reaches the
back of the unit.
If it is not securely inserted, it may cause water
leakage during operation.
Also, attach the filter while holding down the unit.
(P.E-39)
Tab
Insertion hole
Insert to the hole
" will
(P.E-39)
Insert the filters
with caution as
they may get stuck
inside the unit.
Filter assembly
Slide the switch downward.
Switch
Pre-filter
Side cover
Humidifying filter
Humidifying filter
Water tray
Set by aligning the broad sides
Deodorizing filter
E-15