Switching Touch Operation Panel Display - Hitachi EP-A9000 Instruction Manual

Switching Touch Operation Panel Display

 Use this to adjust the unit to your preferred setting.
Long-press
·
display
Dimmer
Type 1/2/Off
The touch operation panel display will switch at each press.
Display 1
 If the lights in the touch operation panel display are turned off, tap the
played.
(Tapping the again turns off the indicator of the touch operation panel display.)
Operation Panel
Display
Select operation mode and airflow rate by
tapping the panel.
For power saving, the display and operation
Display 1
panel other than the notifi cation display and
the air sensor will turn off approximately one
minute after the unit stops operating.
When all indicators are on, tapping the op-
eration panel and selecting operation mode,
airfl ow rate or other similar buttons will make
the display light of the selected buttons
Display 2 brighter.
* The display may not be clear to look at
when the unit is placed near windows with
direct sunlight, and other similarly bright
places.
Display is the same as Display 1.
The display and operation panel, as well as
Off the notification display will turn off approxi-
mately one minute after the unit stops oper-
ating.
 In this instruction manual, the following examples are described in Display 1.
for about 3 seconds and select touch operation panel
Display
Display 2 Off (When switching from Off to Display 1, the buzzer will ring twice
(beep, beep) and the display will blink once. )
Display Contents of the Operation Panel
Display Contents
and operate after the panel is dis-
Example
Max
Air Purify
Air
Display Timer Mode
flow
· · ·
Lock Dimmer Maintenance
Type 1/2/Off Reset
(When selecting Air Purify / Max)
Skin Moist
4hr
Humidify Max
2hr Air Purify Auto
Air
Mode
Display Timer
flow
· · ·
Lock Dimmer Maintenance
Type 1/2/Off Reset
(When selecting Air Purify / Max)
(When indicators are dimmed)
Off
PM2.5
Option
Sensor
On
Odor Absence
Off
Pollen Rapid
PM2.5
Option
Sensor
E-19