Starting Setuptool - Mitsubishi Electric Melsensor CF37-SR Settings Manual

5.2

Starting SetupTool

Start SetupTool.
The [Connect] in the [Home] tab is displayed immediately after starting SetupTool.
When SetupTool recognizes a code reader, "Name," "Address," "Firmware Version," and "Status" of the code reader are
displayed under the "Network" section and the information can be checked.
Whether the IP address matches with the one set in the connected personal computer can be checked in "Status."
<When the status is "Misconfigured">
This indicates the IP address of the code reader and the personal computer are not matched. Either one of the addresses
needs to be changed.
<When the status is "Discovered">
This indicates the IP addresses are matched. A connection can be made by selecting the code reader icon and click the
[Connect] button on the lower right of the screen.
Precautions
■ When a code reader is not recognized
When a code reader is not recognized, try the following operations:
• Click [Update].
• Check that the cables are properly connected.
• Allow the communication in the settings of a firewall or security software.
For details, refer to the following:
Page 21 When communication with DataMan Setup Tool is not allowed by a firewall
5 CONNECTING with SetupTool
20
5.2 Starting SetupTool