Table of Contents
Advertisement
IP Address Check and Ping Test
•
The detector has a default IP address.
•
If the IP address of the detector is changed, a new IP address must be entered in the detector IP in the Calibration tool.
•
After completing the IP Address and [Timeout] settings, click the [Ping] button to run a [Ping Test]. A pop-up message appears when the [Ping Test] is successful.
•
If the [Ping Test] fails, a pop-up appears as shown below. If this pop-up appears, check your PC network settings, detector-to-PC connection, status of the detector, status of the Control Box, and IP address, and run
the [Ping Test] again.
15
Advertisement
Chapters
Table of Contents
