Installing Tile Slider Assembly - Sharp SRS Mounting System Installation Manual

6
IN S TAL L AT I O N WO Rk

6.7 INSTALLINg TILE SLIdER ASSEMbLy

Note: Foot placement for tile roof.
Walking up and down roof
Balance weight in
pan where tiles overlap
Walking across roof
Spread weight across two tiles
• Toe on top of tile 1
• Arch on pan overlap
• Heel on top of tile 2
1. Identify the locations for the roof tile sliders so that
each slider is located in the valley of the tile.
2. Number two tiles, one above the other. The lower
tile will be removed to install the aluminum support
plate.
3. Mark the edge of the upper tile on the lower tile to
insure proper alignment upon assembly.
Draw a guide line for the cut with chalk at the
point of overlap by the next highest tile
Tile 1
Line for Drill Guide
 7
Rafter chalk line
Array horizontal
chalk line
Rafter chalk line
Number the tiles so you
can replace them in the
original positions
Tile to remove
Tile
1