Installing Side Cover; Connecting The Solar Modules - Sharp SRS Mounting System Installation Manual

6
IN S TAL L AT IO N WO Rk
Asphalt shingle
Tile mounting

6.1 INSTALLINg SIdE COvER

Attach the side covers to the open ends of the rail
covers.
Use two side cover screws to secure each cover.
To save time, install side covers prior to installing rail
covers.

6.14 CONNECTINg THE SOLAR MOduLES

1. Connect each module according to the solar array
connection examples.
2. There is a cable + (positive) and a cable - (negative)
on the back side of each solar module. Connect the
waterproof connectors on these cables, making sure
to push the connectors all the way in.
Module output cable + (positive)
Waterproof connector
Module output cable - (negative)
SRS cross section
CAUTION
all the way in. Loose connections can result in heat,
burns, and other damage.
3. On the first solar module, connect the positive home
run cable to the positive array output cable, and
connect the negative cable to the positive cable of the
second solar module.
On the second solar module, connect the negative
cable to the positive cable of the third solar module.
Continue until you have series connected the
appropriate number of modules for the desired
voltage.
 6
Side Cover
Side cover
screws
Be sure to always push the connectors