Sharp SWD-78EHL-SL Service Manual page 19

page 22
vpanel.
16.5 Install the LED light assembly to the new front panel assembly.
16.6 Insert the hooks of the new top front panel assembly into the holes on the side panel, then
screw on the bolts on the top.
16.7 Connect the tap pusher and tap stick in place.
16.8 Install the top cover, middle panel and door back.
17. Change door assembly
17.1 Take off the door rope by unscrewing one bolt on the door.
17.2 Remove the door hinge plate by unscrewing 3 bolts.
17.3 Take away the door together with the hinge plate.
17.4 Plug the door shaft and hinge plate into the new door.
17.5 Install the new door together with shaft and hinge plate,
then screw on the bolt for door rope.
17.6 Close the door check the gaps and if it works properly.
18. Change middle panel
18.1 Remove the door together with the hinge plate.
18.2 Remove the middle panelv
18.3 Take off the middle panel.
18.4 To install the new middle panel, Screw on 4 bolts into the thread holes. NOTE: do not fasten
these 4 bolts but leave a 3-4mm gap.
18.5 Align the holes on the middle panel with the pins on the top front panel then insert up.
18.6 Fasten the 4 bolts from back by using long screw driver.
19. Change IMD panel or insert panel (no display)
19.1 Remove the insert panel for IMD by press the hooks at the bottom.
19.2 Take the IMD or insert panel panel out gently, For IMD panel: unplug all the wires by press
down the wire connector clamps.
19.3 To change IMD panel: install the control board in place by hooks first with static protection
How to change parts