Operation Guide - Sharp SWD-78EHL-SL Service Manual

page 4

5. Operation guide

CAUTION
This dispenser is intended for water dispensing only. Do NOT use other liquids. Do NOT use
for other purposes. Warranty is void if used for any other liquids including coffee, tea, juices,
beer or wine.
This dispenser has been designed to use water bottles with a 3, 5 or 5.2 gallon capacity. Do
NOT use alternative bottles.
Initial Set Up
Do NOT plug in until steps 1-3 are completed.
1. Allow unit to sit upright for 4 hours.
2. Set probe length.
• Adjust the length of the probe by pulling the B portion of the tube to its
proper length. Insert the probe into the bottle and push it down.
(See illustration on right)
3. Install bottle.
• Open door and place fresh bottle in front of tray.
• Clean fresh bottle with a soft cloth and warm soapy water then inse.
• Remove entire plastic cap from top of bottle.
• Insert probe into bottle.
• Push down on probe until it is seated.
NOTICE: When using a 5 gallon rectangular bottle, slide into place as shown in llustration below.
4. Plug cord into a properly grounded wall outlet.
• Water will be pumped into hot and cold water reservoirs from the bottle.
5. Turn energy saving switches on back of dispenser to ON.
• The red switch controls the heating of water. If you do not want hot water, leave this switch OFF
• The blue switch controls the cooling of water. If you do not want cold water, leave this switch OFF.
Notice:
• It will take up to 3 minutes for the reservoirs to load.
• Diring the use pump will come on to refill the tanks ,This is normal.
Operation guide
A
B