RRU
User Guide
To protect the equipment and find out the cause in the case of goods damage, you must
l
l
----End
3.3.2 Tools and Instruments for NodeB Installation
This describes the general tools, special tools, and instruments required for the NodeB
installation.
Table 3-1
Table 3-1 Tools and instruments
General tools
Special tools
Issue 01 (2008-04-18)
CAUTION
Store the unpacked equipment and packing materials indoors.
Take photos of the storage environment, rusted or corroded devices, and packing cases and
materials, and then file the photos.
lists the tools and instruments that need to be prepared before installation.
Measuring
tools
Marking
tools
Drilling tools
Clamping
tools
Pliers
Auxiliary
tools
Earth resistance tester, ESD wrist strap, a pair of ESD gloves, wire
stripper, a clamping pincers, feeder cutter, a pair of crimping pliers for
SMB, RJ-45 connector crimping pliers, wire punchdown tool, wire cutter,
non-conductive screwdriver, safety knife, stripper for 75-ohm coaxial
cables, a pair of connector crimping pliers for 75-ohm coaxial cables, and
a pair of multi-purpose crimping pliers
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
3 Installing RRU and SRXU Hardware
Long tape, 50 mm ribbon tape, 5 m measuring tape, 400
mm level bar, and level instrument
Marking pen and pencil
Percussion drill (with the Ф6, Ф8, Ф10, Ф12, Ф14, and
Ф16 bits) and vacuum cleaner
Straight screwdrivers (M3-M6)
Cross screwdrivers (M3-M6)
Adjustable wrench
Socket wrenches (M6, M8, M12, M14, M17, and M19)
Double offset ring wrenches (M6, M8, M12, M14, M17,
and M19)
Combination wrench M17 and M19
Long-arm wrench
Sharp-nose pliers, diagonal pliers, pincer pliers, hand-
held electric drill, file, handsaw, crowbar, rubber
hammer, and claw hammer
Brush, tweezers, paper knife, bellows, plumb, soldering
iron, solder wires, fork, ladder, heat blower, solder
absorber, insulating tape, and USB memory
3-29