Electrical Connections For 8 Ampere Power Supply; Figure 2-9 External Dc Power Source Connections - Using Portable Radio In Nema4 Housing - Motorola IRRInet-XL Owner's Manual

Solar Panel
Figure 2-9 External DC Power Source Connections – Using Portable Radio in
NEMA4 Housing Enclosure
2.5.3

Electrical Connections For 8 Ampere Power Supply

The 8 Ampere power supply is used for AC power supply connections with
Mobile Radio(s) ONLY in the IRRInet-XL RTU. The 8 Ampere power supply
provides DC power to the Mobile Radio(s), to the Power Supply Module (Less) of
the IRRInet-XL, and to charge the RTU Backup Battery.
The following 8 Ampere power supply models are used:
1. FPN5128 – 115VAC, 8.0 Amp
2. FPN5228 – 230 VAC, 8.0 Amp
For information on the 8 Ampere Power Supply, refer to the MOSCAD Service
Manual CD p/n: 9808901C76.
Assembly Instructions:
1. Be sure that the line power is off before connecting wires to the 8 Ampere
power supply.
2. The operating voltage of the 8 Ampere power supply is indicated on its front
panel above the TB. Make sure that this voltage matches your line voltage.
3. Remove the protective plastic cover from the power supply TB.
For line voltages of 115VAC or 230VAC connect the power wiring as shown
in Figure 2-10.
Use the RTU grounding strip for the line ground input.
Portable
Radio
Battery
Customer Cable
FKN4465
Note: Place Line filter here.
Refer to Chapter 7
FKN4469
FKN8024
Power Supply
Module - Less
(FPN5957)
POWER
SUPPLY
BAT
AUX
DC
ON
OFF
PWR
PWR
IN
2-8