Table of Contents
Advertisement
TCD300E(e).book Page 12 Tuesday, October 12, 2004 8:22 PM
Preparation
Battery life
After your Panasonic batteries are fully
charged, you can expect the following
performance:
Ni-MH batteries (700 mAh)
Operation
While in use (talking)
While not in use
(standby)
Note:
L Actual battery performance depends on a
combination of how often the handset is in
use (talking) and how often it is not in use
(standby).
L Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
Screen saver mode
The backlight will turn off completely after 1
minute of inactivity if the handset is not on
the base unit. Only essential icons and the
date and time will be displayed, and they will
occasionally change position in order to
preserve the life of the display.
Example:
17 May 15:30
To use the handset when it is in screen
saver mode, first press {ih} to turn the
display on again.
12
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Battery replacement
If 3 flashes even after the handset
batteries have been charged for 7 hours, the
batteries must be replaced.
Important:
Operating time
L Use only the Panasonic rechargeable
16 hours max.
170 hours max.
L Do not mix old and new batteries.
1
2
Turning the power on/off
1
Power on
Press {ih} for about 1 second.
L The display will change to the standby
Power off
Press {ih} for about 2 seconds.
L The display will go blank.
batteries noted on page 5. If you install
non-rechargeable batteries and start
charging, the batteries may leak
electrolyte.
Press the notch on the handset cover
firmly and slide it in the direction of the
arrow.
Remove the old batteries positive (S)
terminal first and install the new ones.
See page 11 for battery installation.
mode.
Advertisement
Table of Contents
