Display Setup; Display Setup - Panasonic KX-TCD300E Operating Instructions Manual

Hide thumbs Also See for KX-TCD300E:
Table of Contents

Advertisement

TCD300E(e).book Page 23 Tuesday, October 12, 2004 8:22 PM
Selecting categories to bypass night
mode
1
Press $ (middle soft key).
2
Select Y, then press ,.
3
Select "Ringer Setup", then press
,.
4
Select "Night Mode", then press
,.
5
Select "Select Category", then
press ,.
6
Press the desired category numbers,
then press ,.
L The selected category number will
flash.
L To cancel a selected category
number, press the number again. The
number will stop flashing.
7
Press {ih}.
Note:
L If a call is received from one of the
categories set to bypass night mode, only
the handset will ring.

Display setup

Selecting wallpaper
You can select the "wallpaper" shown on the
display in standby mode from one of the
preset patterns.
1
Press $ (middle soft key).
2
Select Y, then press ,.
3
Select "Display Setup", then press
,.
4
Select "Wallpaper", then press ,.
L The current wallpaper is displayed.
5
Press {e} or {v} repeatedly to select
the desired item, then press ,.
6
Press {ih}.
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Handset Settings
Note:
L If you select "Off", the display colour will
be changed to the colour you selected for
display colour (page 23).
Selecting a display colour
You can select the desired display colour.
1
Press $ (middle soft key).
2
Select Y, then press ,.
3
Select "Display Setup", then press
,.
4
Select "Display Colour", then press
,.
5
Select the desired colour, then press
,.
6
Press {ih}.
Selecting the standby mode
display
"Base Number": The current base unit
number is displayed.
"Handset Number": The current handset
number is displayed.
"Off": Only the current date and time are
displayed.
1
Press $ (middle soft key).
2
Select Y, then press ,.
3
Select "Display Setup", then press
,.
4
Select "Standby Display", then
press ,.
5
Select the desired setting, then press
,.
6
Press {ih}.
Note:
L If "Base Number" is selected and the
current base unit number is 2, "-2-" is
displayed.
L If "Handset Number" is selected and the
current handset number is 2, "[2]" is
displayed.
23

Advertisement

Table of Contents
loading

Table of Contents