Table of Contents
Advertisement
TCD300E(e).book Page 28 Tuesday, October 12, 2004 8:22 PM
Base Unit Settings
4
Select "Ringer Setup", then press
,.
5
Select "Night Mode", then press
,.
6
Select "Ring Delay", then press
,.
7
Select the desired setting, then press
,.
8
Press {ih}.
Call options
Changing the recall time
Change the recall time, if necessary,
depending on the requirements of your
service provider or PBX.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
29).
4
Select "Call Options", then press
,.
5
Select "Recall", then press ,.
6
Select the desired setting, then press
,.
7
Press {ih}.
Setting pause length
Change the pause length, if necessary,
depending on the requirements of your
service provider or PBX.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
29).
4
Select "Call Options", then press
,.
28
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
5
Select "Pause Length", then press
,.
6
Select the desired setting, then press
,.
7
Press {ih}.
Storing/changing emergency
numbers
These settings determine which phone
numbers can be dialled while the call bar
feature is on (page 24).
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
29).
4
Select "Call Options", then press
,.
5
Select "Emergency No.", then press
,.
6
Select a memory location, then press
,.
L If the memory location already
contains an emergency number, the
number is displayed.
7
Enter/edit the number, then press ,.
L To erase an emergency number, press
and hold {C/T}.
8
Press {ih}.
Setting call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up
to 6 phone numbers to be restricted, and
select which handsets will be restricted.
Storing area codes here will prevent the
restricted handsets from dialling any phone
number in that area code. If a restricted
number is dialled, the call will not be
connected and the restricted number will
flash on the display.
1
Press $ (middle soft key).
Advertisement
Table of Contents
