Quick Setup (Qset); Circuit Condition Display (Lmon); Touchtone Information Display (Putd) - Panasonic KX-TVS50 Installation Manual

SYSTEM MAINTENANCE AND TROUBLESHOOTING

7.2.17 Quick Setup (QSET)

Use the QSET command initially to setup the VPS very roughly when you use it for the first
time or after system initialization.
Note
Quick setup requires VT100 emulation software.
Type QSET, then Press RETURN.

7.2.18 Circuit Condition Display (LMON)

Use the LMON command to display the circuit condition every 1.5 s. To turn off this command,
enter [\].
The following circuit conditions may be displayed.
"Ready"
"Incoming Call"
"Outgoing Call"
"DSP Reset"
"PT connect"
"Error"
$ LMON
No.:
1:
2:

7.2.19 Touchtone Information Display (PUTD)

Use the PUTD command to display the touchtones the VPS receives and sends.
In addition to the touchtones, the following will be displayed—the Incoming Call Service
(Voice Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time
periods that the ports are enabled.
Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The default
setting of this mode for all ports is "OFF".
$ PUTD
Target Port : **
Don't leave enabled after troubleshooting.
$
176
: Possible to serve
: Processing arrival service
: Processing sending service
: Processing DSP reset disposition
: Processing PT connect disposition
: DSP Card is not loaded
Status
Ready
Ready
Installation Manual