Panasonic KX-TVS50 Installation Manual page 298

SYSTEM ADMINISTRATOR'S GUIDE
Parameter
Call Waiting
Sequence
Release
Sequence for
Call Waiting
Inband Signaling Parameters
Use these parameters if the PBX sends touchtones to the VPS to indicate the state of a call
(busy, answered, disconnected, etc.). The integration mode must be set to "Inband". If PBX
type is set to a KX-T series telephone system, the Inband Signaling parameters will
automatically default to the proper codes.
To access the proper menu for Inband Signaling Parameters, follow the menu path
as shown:
System Administration Top Menu-1-6-3-2
The following parameters can be programmed using "0-9", " ", "#", and "A-D".
Parameter
Ringback
Busy
Reorder
DND
Answer
Forward to VM
Ringing
298
Table 75
Value Range
(Default)
The VPS carries out this sequence when performing call
(1)
waiting if the extension being called is busy.
The VPS performs this sequence to release call waiting.
(F)
Table 76
Value Range
(Default)
Indicates "Ringback Tone". Sent to the VPS when the
(1)
extension dialed is ringing.
Indicates "Busy Tone". Sent to the VPS when the
(2)
extension dialed is busy.
Indicates "Reorder Tone". Sent to the VPS when an
(3) invalid extension number is dialed or when inadvertently
connected to another VPS.
Indicates "Do Not Disturb Tone". Sent to the VPS if the
(4)
dialed extension has the Do Not Disturb feature enabled.
Sent to the VPS when the called extension answers the
(5)
call.
Sent to the VPS if the called extension is forwarded to a
(6) voice mail port and that voice mail port is available to
accept the call.
Description/Function
Description/Function
Installation Manual