Table of Contents
Advertisement
2)
Press the <ENTER> button.
f The [Keystone] screen is displayed.
Press as to select [Curved correction].
3)
4)
Press the <ENTER> button.
f The [Curved correction] screen is displayed.
Press asqw to adjust the item.
5)
Items
Press the w button.
Press the q button.
[Curved
correction X/Y
Gain]
Press the a button.
Press the s button.
Press the w button.
Press the q button.
[Curved
correction X
Offset]
Press the a button.
Press the s button.
Press the w button.
Press the q button.
[Curved
correction Y
Offset]
Press the a button.
Press the s button.
Note
f Either [H/V Keystone] or [Corner correction] setting value is valid. If the other item is adjusted after [H/V Keystone] or [Corner
correction] was adjusted, the previous setting value will be reset.
f The [Curved Correction X Offset] and the [Curved Correction Y Offset] cannot be adjusted independently. After adjusting the
[Curved Correction X/Y Gain] at the beginning, please adjust the [Curved Correction X Offset] and the [Curved Correction Y
Offset].
f Press the <KEYSTONE> button on the control panel or on the remote control when the [H/V Keystone], [Corner correction]
or [Curved correction] individual adjustment screen is displaying, the individual adjustment screen will switch as follows.
- [H/V Keystone] [Corner correction] (Upper left) [Corner correction] (Upper right) [Corner correction] (Lower right)
[Corner correction] (Lower left) [Curved correction X/Y Gain] [Curved correction X Offset] [Curved correction Y
Offset] [H/V Keystone] ...
f Correcting up to ±15° for the tilt in the vertical direction and ±15°
adjustments with [Keystone]. However, the image quality will degrade and it will get harder to focus with more correction.
Install the projector so that the correction will be as small as possible.
*1 The tilt in horizontal direction is not available for PT-TX210.
f Screen size will also change when [H/V Keystone] is used to perform various adjustments.
f Aspect ratio of the image size may shift depending on the correction.
Chapter 4 Settings - [Expand] menu
Operation
Extend the vertical lines to left and
right.
Dent the vertical lines to left and right.
Extend the horizontal lines to top and
bottom.
Dent the horizontal lines to top and
bottom.
Used to correct the right side vertical
lines. Extend the top and bottom while
keeping the center part as it is.
Used to correct the left side vertical
lines. Extend the top and bottom while
keeping the center part as it is.
Used to correct the both sides of the
vertical lines. Extend the lower corners
while keeping the center part and the
upper part as they are.
Used to correct the both sides of the
vertical lines. Extend the top corners
while keeping the center part and the
lower part as they are.
Used to correct the right side
horizontal lines. Extend the top and
bottom while keeping the center part
as it is.
Used to correct the left side horizontal
lines. Extend the top and bottom while
keeping the center part as it is.
Used to correct the both sides of the
horizontal lines. Extend the lower
corners while keeping the center part
and the upper part as they are.
Used to correct the both sides of the
horizontal lines. Extend the top corners
while keeping the center part and the
lower part as they are.
Adjustment
for the tilt in the horizontal direction are available for
*1
ENGLISH - 63
Advertisement
Table of Contents
