Table of Contents
Advertisement
<HDMI IN> terminal pin assignments and signal names
Outside view
Even-numbered pins
Odd-numbered pins
Connecting example : AV equipment
Video deck
(TBC built-in)
Attention
f Always use one of the following when connecting a VCR.
- A VCR with built-in time base corrector (TBC).
- A time base corrector (TBC) between the projector and the VCR.
f If nonstandard burst signals are connected, the image may be distorted. In such case, connect the time base corrector
(TBC) between the projector and the external devices.
Note
f For an HDMI cable, use an HDMI High Speed cable that conforms to HDMI standards. If a cable that does not conform to
HDMI standards is used, images may be interrupted or may not be displayed.
f This projector does not support the VIERA link (HDMI).
f When the <VARIABLE AUDIO OUT> terminal is connected with cable, the sound will not be output from the built-in speaker.
f When input S-video signal, the optional D-SUB - S Video Conversion cable (Model No. ET-ADSV) is required.
Chapter 2 Getting Started - Connecting
Pin No.
to
to
Audio equipment
DVD player
Signal names
T.M.D.S data 2+
T.M.D.S data 2 shield
T.M.D.S data 2 -
T.M.D.S data 1+
T.M.D.S data 1 shield
T.M.D.S data 1 -
T.M.D.S data 0+
T.M.D.S data 0 shield
T.M.D.S data 0 -
T.M.D.S clock +
D-sub/component
Conversion cable
DVD player
Pin No.
Signal names
T.M.D.S clock shield
T.M.D.S clock -
CEC
—
SCL
SDA
DDC/CEC GND
+5V
Hot plug detection
Blu-ray disc player with
HDMI terminal
D-SUB - S Video conversion
cable (ET-ADSV)
S-video cable
ENGLISH - 31
Advertisement
Table of Contents
