Connections; Before Connecting To The Projector; Connecting Example - Panasonic PT-FW430E Operating Instructions Manual

Connections

Before connecting to the projector

Read carefully the instruction manual for the device to be connected.
z
Turn off the power switch of the devices before connecting cables.
z
If any connection cable is not supplied with the device, or if no optional cable is available for connection of the
z
device, prepare a necessary system connection cable to suit the device.
Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture.
z
In this case, a time base corrector (TBC) must be connected.
The projector accepts the following signals: VIDEO, S-VIDEO, analogue-RGB (with TTL sync. Level) and
z
digital signal.
Some computer models are not compatible with the projector.
z
When using long cables to connect with each of equipment to the projector, there is a possibility that the image
z
will not be output correctly unless a compensator is used.
For details on what video signals the projector supports, see "List of compatible signals". (
z

Connecting example

Computer (Analog)
Computer (Digital)
Blue ray disk player with HDMI
terminal
Control computer
Control computer
Attention
When connecting with a video deck, be sure to use the one with a built-in time base corrector (TBC) or use a TBC between
z
the projector and the video deck.
If nonstandard burst signals are connected, the image may be distorted. If this is the case, connect a TBC between the
z
projector and the video deck.
Note
When using an HDMI cable, check that it is compliant with the HDMI standard. Using a cable that is not compliant with the
z
HDMI standard may result in problems such as the image cutting out or not appearing.
When connecting the 1 080p signal using HDMI, use a cable compliant with 1 080p signal.
It is possible to connect the HDMI input terminal with an external device having a DVI terminal using an HDMI/DVI
z
conversion cable, but with some devices the images may not appear or other problems may occur. (
It is possible to connect the DVI-I input terminal with an HDMI- or DVI-I compliant device, but with some devices the images
z
may not appear or other problems may be encountered in operation. (
When [AUDIO IN SELECT] is not set correctly, sound may not be heard and other problems may occur. (
z
This projector does not support the Viera link (HDMI).
z
The DVI-I input terminal (digital signal input ) supports only a single link.
z
For the specifications of the RGB signals that can be applied from the PC, refer to "List of compatible signals". (
z
If your computer has the resume feature (last memory), the computer may not function properly until the resume capability
z
is disabled.
When the SYNC ON GREEN signal is input, do not input sync signals to the SYNC/HD and VD terminals.
z
When using the DVI-I input terminal (digital signal input ), EDID settings may be required for some connected devices.
z
( page 48)
Æ
See "Network operation" in the instruction manual on the supplied CD-ROM for the details of wired LAN and wireless
z
communication between the projector and the computer.
Computer
Video deck
(TBC built-in)
OR
Æ page 48)
page 81)
Æ
Audio system
Æ page 48)
Æ
page 59)
Æ
page 81)
25
ENGLISH -