Projecting; Selecting The Image; How To Adjust The State Of The Image - Panasonic PT-FW430E Operating Instructions Manual

Projecting

Check the connections of the peripheral devices and connection of the power cord (
Æ
power ( page 27) to start the projector. Select the image and adjust the state of the image.

Selecting the image

Select an input signal.
The image selected with the <COMPUTER>, <DVI-I>,
<VIDEO/S-VIDEO>, <NETWORK>, or <HDMI> button
is projected. ( Æ page 30)
Attention
Images may not be projected properly depending on the
z
connected device and DVD, video tape, etc. to be played.
Select a system format that is suitable for the input signal
in [TV SYSTEM] or [RGB/YP
Æ
( page 39).
Check the aspect ratio of the screen and the image and
z
select the optimum aspect ratio using [ASPECT] in the
Æ
[PICTURE] menu ( page 42).
How to adjust the state of the
image
1 ) Screw [Lens shift lever]
counterclockwise to unlock [Lens shift
lever].
2 ) Adjust the lens shift.
Adjust the projection position by moving [Lens
shift lever].
Lens shift lever
For details of the adjustable range, see
z
"Adjusting the position using the lens shift
function". ( page 22)
Æ
P ] in the [PICTURE] menu
B R
Æ
3 ) Screw [Lens shift lever] clockwise to
lock [Lens shift lever].
4 ) Adjust the projection angle.
For details, see "Adjusting front adjustable feet".
z
( page 22)
Æ
5 ) Adjust the zoom and the focus.
Turn [Zoom lever] and [Focus lever] to adjust the
image.
Note
It is recommended that the images are projected
z
continuously for at least 30 minutes before the focus is
adjusted.
If you adjust the focus, you may need to adjust the size
z
of the image by moving the zoom lever again.
If keystone distortion occurs, see "KEYSTONE"
z
( Æ page 40).
page 26) and switch on the
Focus lever
Zoom lever
ENGLISH -
29