Table of Contents
Advertisement
mm) from the bottom of the filler neck with
diesel fuel.
4.
Install the fuel tank cap tightly after filling tank.
1. Fuel tank cap
Check the Rear Axle Lubricant
The rear axle has three separate reservoirs that use
SAE 80W-90 weight gear lube. Although the axle is
shipped with lubricant from the factory, check the
level before operating the machine.
1.
Position the machine on a level surface.
2.
Remove the check plugs from the axle and make
sure lubricant is up to the bottom of each hole. If
the level is low, remove the fill plugs and add
enough lubricant to bring the level up to the
bottom of the check plug holes (Fig. 6).
2
1
1. Check plug
2. Fill plug
1
Figure 5
Figure 6
1. Fill/check plug (one on each end of the axle)
Check the Bi-Directional
Clutch's Lubricant
1.
Position the machine on a level surface.
2.
Rotate the clutch (Fig 8) so the check plug
(shown in the 12:00 o'clock position) is
positioned at 4:00 o'clock.
2
1. Bi-directional clutch
2. Check plug
3.
Remove the check plug. Fluid level should be up
to the hole in the clutch. If the fluid level is low,
add Mobil Fluid 424. The clutch should be
approximately
4.
Install the check plug.
Note: do not use engine oil (i.e., 10W30) in the bi-
directional clutch. Anti-wear and extreme pressure
additives will cause undesirable clutch performance.
17
1
Figure 7
1
Figure 8
1
⁄
full.
3
Advertisement
Table of Contents
